- Manufacturer-spec systems
- Built for coastal BC weather
BC Traffic Coating installs coating and waterproofing systems on parkades, decks, and structural concrete across British Columbia. Our certified applicators work to manufacturer specification — surface preparation, film thickness, and cure times held to the numbers the system was tested at, because those numbers are what decide whether it lasts.
A multi-level parkade, a residential balcony, and an exposed structural slab each fail in a different way. We assess the substrate, the traffic it carries, and the water it has to shed, then specify a system matched to those conditions instead of applying the same build to every surface.
- Systems Matched to the Surface
- Continuous at Every Detail
- Slip-Resistant Where It Matters
- Built for Coastal BC Weather
One job, start to finish
A parkade entrance, from bare slab to sealed deck
The same doorway photographed at three stages of the same job. Most of what decides whether a coating lasts happens before any membrane goes down, so the preparation is shown here too, not just the result.
View more projectsPeace of Mind
Certified Applicators
Measured, Not Guessed
Details Where Coatings Fail
Manufacturer-Spec Materials
Checked at Every Stage
Priced to the Scope
Get started
Request Your Free Quote
How It Works
- Tell us who you are and how to reach you.
- Pick the service your surface needs, if you know it.
- Add square footage and location if you know them, then send it over.